Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 71

Example Supported Releases OS10# lock 10.2.0E or later management route Configures an IPv4/IPv6 static route the Management port uses. To configure multiple management routes, repeat the command. Syntax Parameters management route {ipv4-address/mask | ipv6-address/prefix-length} {forwarding-router-address | managementethernet} ● ipv4-address/mask - Enter an IPv4 network address in dotted-decimal format (A.B.C.D), then a subnet mask in prefix-length format (/xx). ● ipv6-address/prefix-length - Enter an IPv6 address in x:x:x:x::x format with the prefix length in /xxx format. The prefix range is /0 to /128. ● forwarding-router-address - Enter the next-hop IPv4/IPv6 address of a forwarding router (gateway) for network traffic from the Management port. ● managementethernet - Configure the Management port as the interface for the route and associates the route with the Management interface. Default Command Mode Usage Information Example (IPv4) Not configured CONFIGURATION Management routes are separate from IP routes and are only used to manage the switch through the Management port. To display the currently configured IPv4 and IPv6 management routes, use the show ip management-route and show ipv6 management-route commands. OS10(config)# management route 10.10.20.0/24 10.1.1.1 OS10(config)# management route 172.16.0.0/16 managementethernet Example (IPv6) OS10(config)# management route 10::/64 10::1 Supported Releases 10.2.2E or later move Moves or renames a file in the configuration or home system directories. Syntax Parameters move [config: | home: | usb:] ● config: - Move from the configuration directory (config://filepath). ● home: - Move from the home directory (home://filepath). ● usb: - Move from the USB file system (usb://filepath). Default Command Mode Usage Information Example Not configured EXEC Use the dir config command to view the directory contents. OS10# move config://startup.xml config://startup-backup.xml Example (dir) OS10# dir config CLI Basics 71