Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 570

Configuration notes All Dell EMC PowerSwitches except MX-Series, S4200-Series, S5200 Series, and Z9332F-ON: Before you assign the management port to the management VRF instance, you must remove all configured settings on the management port, including the IP address. Perform this action from the console. Removing the IP address disconnects all existing SSH and Telnet sessions on the switch. The following example shows removing IP address, configuring management VRF, and then adding IP address: OS10(conf-if-ma-1/1/1)# do show version Dell EMC Networking OS10 Enterprise Copyright (c) 1999-2020 by Dell Inc. All Rights Reserved. OS Version: 10.5.2.0 Build Version: 10.5.2.0.99999 Build Time: 2020-08-21T05:54:18+0000 System Type: S5248F-VM Architecture: x86_64 Up Time: 4 days 03:46:41 OS10(conf-if-ma-1/1/1)# OS10(config)# ip vrf management OS10(conf-vrf)# interface management % Error: Configurations are existing in interface mgmt1/1/1 OS10(conf-vrf)# exit OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# show configuration ! interface mgmt1/1/1 no shutdown no ip address dhcp ip address 100.104.34.30/24 ipv6 address autoconfig OS10(conf-if-ma-1/1/1)# no ip address OS10(conf-if-ma-1/1/1)# no ipv6 address autoconfig OS10(conf-if-ma-1/1/1)# exit OS10(config)# ip vrf management OS10(conf-vrf)# interface management OS10(conf-vrf)# exit OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ip address 100.104.34.30/24 OS10(conf-if-ma-1/1/1)# show configuration ! interface mgmt1/1/1 no shutdown no ip address dhcp ip address 100.104.34.30/24 OS10(conf-if-ma-1/1/1)# do show ip vrf management VRF-Name Interfaces management Mgmt1/1/1 OS10(conf-if-ma-1/1/1)# Configure a static route for a management VRF instance Configure a static route that directs traffic to the management interface: management route ip-address mask managementethernet Or management route ipv6-address prefix-length managementethernet You can also configure the management route to direct traffic to a physical interface. For example: management route 10.1.1.0/24 managementethernet Or management route 2::/64 managementethernet 570 Layer 3