Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 508

When the number of calls exceeds the configured threshold, MSTP ignores further (VLAN-list, port) based flush and starts the MAC flush timer. When the timer starts, the system blocks all further flush indications. When the timer expires for that specific instance, the system triggers instance-based flushing. The default MAC flush threshold value for MSTP is 5. Rapid-PVST Rapid-PVST allows (VLAN, port) based flush until the number of calls sent is equal to the MAC flush threshold value that is configured. When the number of calls sent exceeds the configured threshold, rapid-PVST ignores further (VLAN, port) based flush and starts the MAC flush timer. When the timer starts, the system blocks further flush. When the timer expires for that specific instance, the system triggers VLAN-based flushing. By default, the MAC flush threshold value is set to 5. However, Dell EMC recommends that you configure this value based on the number of ports that participate in the STP topology. Spanning-tree link type for rapid state transitions As specified in IEEE 802.1w, OS10 assumes a port that runs in full-duplex mode is a point-to-point link. A point-to-point link transitions to forwarding state faster. By default, OS10 derives the link type of a port from the duplex mode. You can override the duplex mode using the spanning-tree link-type command. OS10 assumes a port that runs in half-duplex mode is a shared link, to which the fast transition feature is not applicable. Also, If you explicitly designate a port as a shared link, you cannot use the fast transition feature, regardless of the duplex setting. To hasten the spanning-tree state transitions, you can set the link type to point-to-point. To set the link type to point-to-point: ● Use the following command in INTERFACE mode. spanning-tree link-type point-to-point Dynamic path cost calculation Path cost of an interface (physical or port-channel) is calculated based on the speed of the port or port-channel. When the speed of the port or port-channel changes, the past cost recalculation is triggered based on the user defined configuration. You can enable/disable dynamic recalculation of path cost using the spanning-tree path-cost command. This cmd allows the protocol to do dynamic cost calculation whenever the channel-members are added or deleted. By default, this dynamic path cost calculation is enabled. When dynamic path cost is disabled , protocol calculate the path cost when the port channel is coming up for the first time after creation or whenever dynamic path cost calculation is enabled and then disabled by management or when the user adds/ removes member port to/from the port channel. This feature allows the user to disable path cost re-calculation on link flap events. If disabled, the path cost of the lag is calculated based on the below formula LAG speed = speed of a single member * number of configured member ports (irrespective of its oper status). Path cost changes only for the user event [addition/removal of channel-member]. Path cost is calculated based on the number of configured ports. Dynamic path cost disable functionality is supported for VLT port channel. Debug facilities Use the debug spanning-tree bpdu command to monitor and verify that the MST configuration is communicating as configured. To ensure all necessary parameters match - region name, region version, and VLAN to instance mapping, examine your individual devices. Use the show spanning-tree mst command to view the MST configuration, or use the show running-configuration command to view the overall MST configuration. MST flags for communication received from the same region The MST routers are located in the same region. If the debug logs indicate that packets are coming from a Different Region, one of the key parameters does not match. 508 Layer 2