Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 164

Default Command Mode Usage Information Example ● mgmt node/slot/port-Enter the Management port interface information. Not configured CONFIGURATION The no version of this command removes the configuration. OS10(config)# ntp source ethernet 1/1/24 Supported Releases 10.2.0E or later ntp trusted-key Sets a key to authenticate the system to which NTP synchronizes with. Syntax Parameters Default Command Mode Usage Information Example ntp trusted-key number number-Enter the trusted key ID, from 1 to 4294967295. Not configured CONFIGURATION The number parameter must be the same number as the number parameter in the ntp authentication-key command. If you change the ntp authentication-key command, you must also change this command. Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S). Also supported in SmartFabric mode starting in release 10.5.0.1 The no version of this command removes the key. OS10(config)# ntp trusted-key 234567 Supported Releases 10.2.0E or later show ntp associations Displays the NTP master and peers. Syntax Parameters show ntp associations [vrf {management | vrf-name}] ● management-Enter the keyword to display NTP information corresponding to the management VRF instance. ● vrf-name-Enter the keyword then the name of the VRF to display NTP information corresponding to that nondefault VRF instance. Default Command Mode Usage Information Not configured EXEC ● (none)-One or more of the following symbols displays: ○ *-Synchronized to this peer. ○ #-Almost synchronized to this peer. ○ +-Peer was selected for possible synchronization. ○ --Peer is a candidate for selection. ○ ~-Peer is statically configured. ● remote-Remote IP address of the NTP peer. ● ref clock-IP address of the remote peer reference clock. 164 System management