Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1390

show qos maps (Z9332F-ON) Displays the QoS maps configuration of the dot1p-to-traffic class, DSCP-to-traffic class, and traffic-class to queue mapping in the device. Syntax Parameters show qos maps type tc-queue ● qos - Enter to view either an ingress or egress QoS configuration ● maps - Enter to view QoS mapping information ● type- (Optional)Enter to view Qos map types ● tc-queue - Enter to view the traffic class-to-queue map Default Command Mode Usage Information Example NA EXEC The command applies to the Z9332F-ON only. The command provides priority-to-traffic-class and trafficclass-to-queue mapping, both default and user configured. The Type column displays the queue type corresponding to the traffic-class-to-queue map entry. For platforms other than Z9332F-ON, the Both displays in the Type column to indicate that the mapping applies to both unicast and multicast queues. show qos maps type tc-queue Traffic-Class to Queue Map: sundar Queue Traffic-Class Type 2 2-5 Unicast 0-2 0 Multicast Supported Releases 10.5.0 or later show qos port-map details Displays port to port pipe and MMU mapping. Syntax Parameters Default Command Mode Usage Information show qos port-map details [interface interface-type] interface interface-type - (Optional) Enter the keyword interface and the interface type. Not configured EXEC On the Z9100-ON, Z9264F-ON, and MX9116n platforms, interfaces are shared across port pipes and port pipes are shared across Memory Management Units (MMUs). As interfaces span port pipes, Dell EMC Networking recommends using interfaces from same port pipes for both ingress and egress for optimal performance. To find the port to port-pipe and MMU mapping, use the show qos port-map details command. Example Z9100-ON switch: OS10# show qos port-map details Interface Port Pipe Ingress MMU Egress MMU Oper Status Eth 1/1/1 1 2, 3 0, 2 up Eth 1/1/2 1 2, 3 0, 2 up Eth 1/1/3 1 2, 3 0, 2 up 1390 Quality of service