Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1117

User management commands disable Lowers the privilege level. Syntax Parameters disable privilege-level ● privilege-level-Enter the privilege level, from 0 to 15. Defaults Command Mode Usage Information Example 1 Privileged EXEC If you do not specify a privilege level, the system assigns level 1. OS10# disable Supported Releases OS10# disable 6 10.4.3.0 or later enable Enables a specific privilege level. Syntax Parameters enable privilege-level ● privilege-level-Enter the configured privilege level, from 0 to 15. Defaults Command Mode Usage Information 15 Exec Dell EMC Networking recommends configuring a password for privilege level 15 using the enable password command. If you do not configure a password for a level, you can switch to that level without entering a password, unless a password is configured for a highest intermediate level. If you configure a password for an intermediate level, enter that password when prompted. To access privilege level 15, you must configure the enable password command. If you do not configure a password for privilege level 15, you cannot enter level 15. For privilege levels 0 to 14, the enable password command is optional. Privilege levels inherit all permitted commands from all lower levels. For example, if you log in to privilege level 10 using the enable 10 command, all commands that are assigned to privilege level 10 and lower are available for use. Example OS10# enable Supported Releases OS10# enable 10 10.4.3.0 or later enable password priv-lvl Sets a password for a privilege level. Syntax Parameters enable password encryption-type password-string priv-lvl privilege-level ● encryption-type - Enter the type of password encryption: Security 1117