Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1423

delay-restore Configures a time interval to delay bringing up the VLT ports after reload or peer-link restoration between the VLT peer switches. Syntax Parameters Default Command Mode Usage Information Example delay-restore seconds seconds - Enter a delay time, in seconds, to delay bringing up VLT ports after the VLTi link is detected, from 1 to 1200. 90 seconds VLT-DOMAIN Use this command to delay the system from bringing up the VLT port for a brief period to allow the exchange of control information, such as, MAC and ARP tables between VLT peers. If the peer VLT device was up at the time the VLTi link failed, use this command after you reload a VLT device. The no version of this command resets the delay time to the default value. OS10(conf-vlt-1)# delay-restore 100 Supported Releases 10.3.0E or later discovery-interface Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers. Syntax Parameters Default Command Mode Usage Information discovery-interface {ethernet node/slot/port[:subport]} ethernet - Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens and commas. None VLT-DOMAIN The VLT node discovery service automatically connects the discovery port to its peer node port and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration. NOTE: Dell EMC recommends that you disable flow-control on discovery interfaces. Use the no flowcontrol receive and no flowcontrol transmit commands to disable flow-control. Example OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15 OS10(conf-if-eth1/1/15)# no flowcontrol receive OS10(conf-if-eth1/1/15)# no flowcontrol transmit Example (range) OS10(config)# vlt-domain 2 OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/2 OS10(conf-if-eth1/1/1)# no flowcontrol receive OS10(conf-if-eth1/1/1)# no flowcontrol transmit Supported Releases OS10(conf-if-eth1/1/2)# no flowcontrol receive OS10(conf-if-eth1/1/2)# no flowcontrol transmit 10.2.0E or later Virtual Link Trunking 1423