Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 69

end Returns to EXEC mode from any other command mode. Syntax Parameters Default Command Mode Usage Information Example end None Not configured All Use the end command to return to EXEC mode to verify currently configured settings with show commands. OS10(config)# end OS10# Supported Releases 10.2.0E or later exit Returns to the next higher command mode. Syntax Parameters Default Command Mode Usage Information Example exit None Not configured All None OS10(conf-if-eth1/1/1)# exit OS10(config)# Supported Releases 10.2.0E or later hostname Sets the system host name. Syntax Parameters Default Command Mode Usage Information hostname name name - Enter the host name of the switch, a maximum of 64 characters. OS10 CONFIGURATION The host name is used in the OS10 command-line prompt. The MX7000 series switch, not the Dell EMC SmartFabric OS10, automatically sets the default hostname using a module-slot format. To calculate the hostname, the switch takes into account the module that is currently plugged into the MX7000 chassis and the slot in the chassis where the module is inserted. The module can be either MX9116n or MX5108n. NOTE: To make the switch automatically set the default hostname using the module-slot format, before upgrading to version 10.5.0, remove the user-defined hostname or set the default hostname using the no hostname command. CLI Basics 69