Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 62

Copy running configuration to local directory or remote server OS10# copy running-configuration {config://filepath | home://filepath | ftp://userid:passwd@hostip/filepath | scp://userid:passwd@hostip/filepath | sftp://userid:passwd@hostip/filepath | tftp://hostip/filepath} OS10# copy running-configuration scp://root:[email protected]/tmp/qaz.txt Copy file to running configuration To apply a set of commands to the current running configuration and execute them immediately, copy a text file from a remote server or local directory. The copied commands do not replace the existing commands. If the copy command fails, any commands that were successfully copied before the failure occurred are maintained. OS10# copy {config://filepath | home://filepath | ftp://userid:passwd@hostip/filepath | scp://userid:passwd@hostip/filepath | sftp://userid:passwd@hostip/filepath | tftp://hostip/filepath | http://userid@hostip/ filepath} running-configuration OS10# copy scp://root:[email protected]/tmp/qaz.txt running-configuration Copy running configuration to startup configuration To display the configured settings in the current OS10 session, use the show running-configuration. To save new configuration settings across system reboots, copy the running configuration to the startup configuration file. OS10# copy running-configuration startup-configuration Restore startup configuration The startup configuration file, startup.xml, is stored in the config system folder. To create a backup version, copy the startup configuration to a remote server or the local config: or home: directories. To restore a backup configuration, copy a local or remote file to the startup configuration and reload the switch. After downloading a backup configuration, enter the reload command, otherwise the configuration does not take effect until you reboot. NOTE: A non-default switch-port profile is not automatically restored. If the downloaded startup configuration you want to restore contains a non-default switch-port profile, you must manually configure and save the profile on the switch, and then reload the switch for the profile settings to take effect. If the backup startup file contains the default switch-port profile, you can simply copy the startup configuration file from the server and reload the switch. Copy file to startup configuration OS10# copy {config://filepath | home://filepath | ftp://userid:passwd@hostip/filepath | scp://userid:passwd@hostip/filepath | sftp://userid:passwd@hostip/filepath | tftp://hostip/filepath} config://startup.xml Back up startup file OS10# copy config://startup.xml config://backup-9-28.xml Restore startup file from backup OS10# copy config://backup-9-28.xml config://startup.xml OS10# reload System configuration has been modified. Save? [yes/no]:no Back up startup file to server OS10# copy config://startup.xml scp://userid:password@hostip/backup-9-28.xml 62 CLI Basics