Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 362

Usage Information Example Supported Releases ● The configurations are supported only in the multiswitch mode. ● This command configures the cost of the selected interface. Also, it configures the same cost value on both ends of the link. ● Different cost values lead to repeat the request repeatedly or even indefinitely. ● The no version of this command resets the command to default value, for the interface speed. OS10(config-if-fc-1/1/1)#fspf cost 90 10.5.1.0 or later fspf dead-interval Configures the FSPF dead Interval value for every interface. Syntax Parameters fspf dead-interval timeout-val timeout-val-Valid values are from 1 to 65535. Defaults Command Mode Usage Information 80 s Fiber channel INTERFACE ● The configurations are supported only in the multiswitch mode. ● This command specifies the maximum interval. You must first receive a hello message on the selected interface before the neighbor is considered lost and removed from the database. ● The no form of this command resets the command to default value, 80 s. Example OS10(config-if-fc-1/1/1)#fspf dead-interval 90 Supported Releases 10.5.1.0 or later fspf hello-interval Configures the FSPF hello interval value for every interface. Syntax Parameters fspf hello-interval timeout-val timeout-val-Valid values are from 1 to 65535. Defaults Command Mode Usage Information 20 s Fiber Channel INTERFACE ● The configurations are supported only in multiswitch mode. ● This command specifies the hello message interval to verify the health of the link in the VSAN. ● The no version of this command resets to the default value. Example OS10(config-if-fc-1/1/1)#fspf hello-interval 30 Supported Releases 10.5.1.0 or later fspf hold-time Configures the FSPF hold-time value for vfabric. Syntax fspf hold-time timeout-val 362 Fibre Channel