Dell Precision 610 Dell Precision WorkStation 610 Mini Tower Systems User's Gu - Page 127
Fit the bracket over the drive, and then tilt the front of the drive up so that
View all Dell Precision 610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
bracket tabs (2) If a drive is already installed in the bay and you are replacing it, be sure to disconnect the DC power cable and interface cable from the back of the drive before sliding the bracket out of the bay. To remove the old drive from the bracket, turn the drive/bracket assembly upside down and unscrew the four screws that secure the drive to the bracket (see Figure 10-7). Turn the drive upside down and locate the four screw holes around its perimeter. Fit the bracket over the drive, and then tilt the front of the drive up so that the bracket drops down into place. To ensure proper installation, all screw holes should be aligned and the tabs on the front of the bracket should be flush with the front of the drive (see Figure 10-7). bracket tabs (2) bracket Installing Drives 10-7