Dell Precision 610 Dell Precision WorkStation 610 Mini Tower Systems User's Gu - Page 178
Card Select Num, Error
View all Dell Precision 610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
WARNING: Could not configure Plug and Play Card Name. WARNING: Could not configure PCI device, ID=DeviceID. Failed to configure Number of Total Count Plug and Play ISA devices. Use your system's configuration utility to resolve conflicts. Press any key to continue. The card(s) mentioned are not fully configured due to resource conflicts. If you do not know the allowable resource values for your Plug and Play or PCI expansion card, use the following procedure to locate and resolve the resource conflict: See "Removing a Card" in Chapter 4 for instructions. The ICU should automatically configure your Plug and Play or PCI expansion card. WARNING: Boot Device conflict detected! CSN=Card Select Number Error=Error. One of the devices is attempting to use one or more resources assigned to the system's boot device. See "Adding a Listed Card" in Chapter 4 for instructions. If your Plug and Play or PCI expansion card is not automatically configured when you reboot the system with all other cards removed, you should contact the manufacturer of the card or see the chapter titled "Getting Help" in your Diagnostics and Troubleshooting Guide. Perform the following procedure: config err This card is attempting to use one or more resources required by the system's boot device. NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary. C-10 Dell Precision 610 Mini Tower Systems User's Guide