Epson 835p User Manual - Page 149

Using a Browser to Monitor Projectors If your projectors are connected to a network (802.11g or 802.11b wireless or wired LAN), you can use a standard web browser to monitor and control each one. 1. Do one of the following: ■ Make sure the projector is set up for your wired LAN network, as described on page 138. (Standby Mode in the Extended menu should be set to Network ON to monitor projectors in standby mode.) ■ Make sure the Epson 802.11g wireless card is inserted in the projector's card slot and the projector is configured for Access Point mode, as described on page 68. 2. Open the web browser and enter the IP address of the projector you want to monitor in the browser window. If you're not sure what address the projector is using, turn it on and switch it to EasyMP. Then choose Basic under Wired LAN or Wireless LAN and press Enter. You see a screen like this, which shows you the IP address: note You can't use your browser to monitor projectors if it is set up to connect via a proxy server. If you are using Microsoft Internet Explorer, use version 6.0 or later. The projector must be plugged in (projecting or in standby mode) for you to be able to monitor it. To access a projector in standby mode, you must select Network ON as the Standby Mode setting in the projector's menu system (see page 134.) Remember that when Standby Mode is set to Network ON, the exhaust fan continues to operate after the projector enters standby mode. 3. If you're connected over a wired network, the projector's web screen opens in the browser window. Managing Projectors 149