Epson Ensemble HD 720 User's Guide - Page 55

6 Press S-UP to raise the screen fully. Note You must raise the screen all the way for the new position to take effect. 7 Press S-DWN re-open the screen. Verify that it comes down and stops at the desired position. Manual Screen Adjustment If you weren't able to adjust the screen length precisely enough using the remote control, you can adjust it using the 4-mm Allen wrench that came with your system. This adjustment sets the maximum length that the screen can come down. Caution Do not allow the screen to descend more than 64 inches (with a black drop of more than 12 inches), or the fabric could separate from the roller. 1 After adjusting the screen length as described in the previous section, press S-DWN on the remote control to lower the screen fully. 2 Locate the lower-limit adjustment screw on the left side of the screen roller, inside the screen casing. Caution Do not turn the upper-limit adjustment screw, located to the rear of the lower-limit adjustment screw. 4-mm Allen wrench 3 Use a 4-mm Allen wrench to rotate the adjustment screw: To raise the screen: Turn the screw clockwise. To lower the screen: Turn the screw counterclockwise. Each turn changes the screen's stop-position by two-thirds of an inch. However, since the screen doesn't move as you adjust it, you'll need to estimate how far to turn the screw. After turning the screw the estimated number of turns, remove the Allen wrench and press S-UP on the remote control to raise the screen fully. Then press S-DWN to re-open the screen. Verify that it comes down and stops at the desired position. 55