Epson TM-m50II Web Config Reference Guide - Page 54
Button, Table 10-18 Button, Table 10-19 Error Pop-up
View all Epson TM-m50II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
"IPv6 Secondary DNS Server" "Power Saving(Wi-Fi)" "Frequency Range (Wi-FiWi-Fi Direct)" "Frequency Range" Set this item in the IPv6 address. Use one of the following formats. xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxxx:xxxx "xxxx" indicates one to four digits in Hexadecimal. Repeated "xxxx" in one location of an IPv6 address that are all "0" can be abbreviated as "::". Shows an error if it includes any of the following address parts. "::/128" "::1/128" "FF00::/8" You cannot register other IPv6 DNS server addresses that have already been registered. You can leave this field blank. - If "IPv6 Setting" is "Disable", this item is greyed-out. Two radio buttons are provided to choose either of the following: "Enable" / "Disable" A dropdown list is provided to choose either of the following: "Auto" / "2.4 GHz" / "5 GHz" Always displayed when in "Kagaribi mode". Displayed only when the Wi-Fi dongle is attached and in "Dongle mode". Displayed when in "Kagaribi mode" if the model is equipped with a 5GHz Wi-Fi chip. Not displayed if the model is only equipped with a 2.4GHz Wi-Fi Chip. Displayed when in "Dongle mode" if a 5GHz dongle is attached. Not displayed if a 2.4GHz dongle is attached or if the dongle is not attached. 10.3.1.1.3 Button Items "Next" Table 10-18 Button Description If pressed, Web Config goes to the Confirm Wi-Fi/Network Settings page. If Web Config recognizes an error in the entered value after the Next button is pressed, the following error pop-up is shown. If the entered value error occurs multiple times, a high priority is displayed. Table 10-19 Error Pop-up Items Description "Invalid value below." This message is shown when the value entered in the text box is invalid. The item names of the corrected values are shown under the message in the left cell. If there are two or more items whose values were corrected, those items are listed line by line. "The combination of IP Address and Subnet Mask is incorrect." This message is displayed if all of the bits in the host "All the bits in the host address part of the IP address cannot be address portion of the IP address are 1. set to 1." "The combination of IP Address and Subnet Mask is incorrect." This message is displayed if all of the bits in the host "All the bits in the host address part of the IP address cannot be address portion of the IP address are 0. set to 0." "The combination of Default Gateway and Subnet Mask is This message is displayed if all of the bits in the host incorrect." address portion of the Default Gateway are 1. "All the bits in the host address part of the Default Gateway cannot be set to 1." "The combination of Default Gateway and Subnet Mask is This message is displayed if all of the bits in the host incorrect." address portion of the Default Gateway are 1. "All the bits in the host address part of the Default Gateway cannot be set to 0." "The combination of IP Address, Subnet Mask and Default This message is shown in the following cases. Gateway is incorrect." A default gateway has been set, and the network part "IP Address and Default Gateway must be on the same network that indicates the subnet mask is different in the IP segment as defined by the Subnet Mask." address and default gateway. 54