HP Color LaserJet CM6049f HP Color LaserJet CM6049f MFP - User Guide - Page 49
Data gathered from the HTTP, SNMP, and Data Path, Execution Time [H]
View all HP Color LaserJet CM6049f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Table 2-11 Jetdirect menus (continued) Menu item Sub-menu item Ping Test Sub-menu item SNMP Test Data Path Test Select All Tests Execution Time [H] Execute Dest Type Dest IPv4 Dest IPv6 Packet Size Timeout Count Print Results Execute Values and Description This test checks operation of SNMP communications by accessing predefined SNMP objects on the device. Select Yes to choose this test, or No to not choose it. This test helps to identify data path and corruption problems on an HP postscript level 3 emulation device. It sends a predefined PS file to the device, However, the test is paperless; the file will not print. Select Yes to choose this test, or No to not choose it. Use this item to select all available embedded tests. Select Yes to choose all tests. Select No to select individual tests. Use this item to specify the length of time (in hours) that an embedded test will be run. You can select a value from 1 to 60 hours. If you select zero (0), the test runs indefinitely until an error occurs or device is turned off. Data gathered from the HTTP, SNMP, and Data Path tests is printed after the tests have completed. No: Do not initiate the selected tests. Yes: Initiate the selected tests. This test is used to check network communications. This test sends link-level packets to a remote network host, then waits for an appropriate response. To run a ping test, set the following items: Specify whether the target device is an IPv4 or IPv6 node. Type the IPv4 address. Type the IPv6 address. Specify the size of each packet, in bytes, to be sent to the remote host. The minimum is 64 (default) and the maximum is 2048. Specify the length of time, in seconds, to wait for a response from the remote host. The default is 1 and the maximum is 100. Specify the number of ping test packets to send for this test. Select a value from 1 to 100. To configure the test to run continuously, select 0. If the ping test was not set for continuous operation, you can choose to print the test results. Select Yes to print results. If you select No (default), results are not printed. Specify whether to initiate the ping test. Select Yes to initiate the test, or No to not run the test. ENWW Initial Setup menu 33