HP Dc7900 Service Reference Guide: HP Compaq dc7900 Business PC - Page 180

Processor 1. Prepare the computer for disassembly (Preparation for Disassembly on page 118). 2. Remove the access panel (Computer Access Panel on page 125). 3. Remove the fan shroud (Fan Shroud on page 161). 4. Remove the heatsink (Heatsink on page 167). 5. Rotate the locking lever to its full open position (1). 6. Raise and rotate the microprocessor retainer to its fully open position (2). 7. Carefully lift the processor from the socket (3). CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and handling them could cause irreparable damage. Once pins are damaged it may be necessary to replace the system board. The heatsink must be installed within 24 hours of installing the processor to prevent damage to the processor's solder connections. Figure 8-63 Removing the processor To install a new processor: 1. Place the processor in its socket and close the retainer. 2. Secure the locking lever. If reusing the existing heatsink, go to step 3. If using a new heatsink, go to step 6. 3. If reusing the existing heatsink, clean the bottom of the heatsink with the alcohol pad provided in the spares kit. CAUTION: Before reinstalling the heatsink you must clean the top of the processor and the bottom of the heatsink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply thermal grease to the top of the processor from the syringe supplied in the spares kit. 168 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis