HP Dc7900 Service Reference Guide: HP Compaq dc7900 Business PC - Page 198
Installing Additional Memory, SODIMMs, DDR2-SDRAM SODIMMs - ultra slim memory
UPC - 884962028483
View all HP Dc7900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
Installing Additional Memory The computer comes with double data rate 2 synchronous dynamic random access memory (DDR2SDRAM) small outline dual inline memory modules (SODIMMs). SODIMMs The memory sockets on the system board can be populated with up to two industry-standard SODIMMs. These memory sockets are populated with at least one preinstalled SODIMM. To achieve the maximum memory support, you can populate the system board with up to 8-GB of memory. DDR2-SDRAM SODIMMs For proper system operation, the SODIMMs must be: ● industry-standard 200-pin ● unbuffered PC2-6400 800 MHz-compliant ● 1.8 volt DDR2-SDRAM SODIMMs The DDR2-SDRAM SODIMMs must also: ● support CAS latency 5 DDR2 800 Mhz (5-5-5 timing) and CAS latency 6 DDR2 800 Mhz (6-6-6 timing) ● contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification In addition, the computer supports: ● 512-Mbit and 1-Gbit non-ECC memory technologies ● single-sided and double-sided SODIMMS ● SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not supported NOTE: The system will not operate properly if you install unsupported SODIMMs. Refer to the Computer Setup (F10) Utility Guide for information on how to determine the processor bus frequency of a specific computer. 186 Chapter 9 Removal and Replacement Procedures Ultra-Slim Desktop (USDT) Chassis