HP GbE2c HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Command Refere - Page 51
RIP user configuration, IP information, IGMP multicast group information - ethernet blade switch trunk interface
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
RIP user configuration NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch. Command: /info/l3/rip/dump RIP USER CONFIGURATION : RIP on updat 30 RIP Interface 2 : 102.1.1.1, enabled version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1 auth none,key none RIP Interface 3 : 103.1.1.1, enabled version 2, listen enabled, supply enabled, default none poison disabled, trigg enabled, mcast enabled, metric 1 IP information Command: /info/l3/ip Interface information: 1: 47.80.23.243 255.255.254.0 47.80.23.255, up Default gateway information: 1: 47.80.22.1, up 2: 47.80.225.2, up Current BOOTP relay settings: OFF 0.0.0.0, 0.0.0.0 Current IP forwarding settings: OFF, dirbr disabled Current network filter settings: none Current route map settings: The following interface and default gateway information is displayed (some fields apply only to the GbE2c Layer 2/3 Ethernet Blade Switch): • Interface number • IP address • IP mask • IP broadcast address • Operational status • BootP relay settings • IP forwarding settings • Network filter settings • Route map settings IGMP multicast group information Command: /info/l3/igmp [IGMP Multicast Group Menu] mrouter - Show IGMP Snooping Multicast Router Port information find - Show a single group by IP group address vlan - Show groups on a single vlan port - Show groups on a single port trunk - Show groups on a single trunk dump - Show all groups The following table describes the commands used to display information about IGMP groups learned by the switch. Table 35 IGMP Multicast Group menu options Information Menu 51