HP Integrity rx4640 Windows Integrity Management Agents Reference - Page 115
Check HSO assembly.
View all HP Integrity rx4640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
11456 11459 11461 11463 11465 11467 11468 11471 11478 11479 11481 11482 11483 11484 11485 11486 11487 11488 11489 11495 11496 11515 11521 11529 System backplane power board has reported a 3.3v house keeping fault. Check system backplane power board. System backplane power board has reported a 12v fault. Check system backplane power board. System backplane power board has reported a 3.3v fault. Check system backplane power board. System backplane power board has reported a 1.5v fault. Check system backplane power board. System backplane power board has reported a 2.5v fault. Check system backplane power board. There has been multiple faults on the same power look for additional events describing action to rail. take. RCS assembly has reported a fault. Check RCS assembly. HSO assembly has reported a fault or has been removed. Check HSO assembly. Operating frequency of the HSO does not match that of the RCS. Check HSO assembly. HSO assembly has been removed or has a fault look for additional events describing action to condition. take. There are no HSO present or all clock sources Look for additional events describing action to have faulted. take. device is not accessible over i2c check HSO + RCS boards device is not accessible over i2c. check HSO and RCS boards device is not accessible over i2c. check backplane power. device is not accessible over i2c. check backplane power device is not accessible over i2c. check backplane power. device is not accessible over i2c. check backplane power check backplane power. The physical location of the MOAB reporting the error is provided by data field. 0xFFFFXXFFFFFFFFFF where XX is: XX = 0x00 - Moab 0x00 XX = 0x01 - Moab 0x01 XX = SBS block for one of the MOAB's has reported an 0x02 - Moab 0x02 XX = 0x10 - Moab 0x40 XX = error on startup. 0x11 - Moab 0x41 XX = 0x12 - Moab 0x42 IO backplane LPM is not accessible over i2c. Check power status of IO backplane. IO Backplane LPM is not accessible over i2c. Check power status of IO backplane. System Software Defect - using the wrong entry address for the owner of the CPU. Update the system software An error occurred while routing the fabric Collect IPMI event logs, and contact your HP support representative to inspect the fabric and system firmware. The fPar whose ID is identified in the event detail is disabled from booting because it has no Use the soft partitioning configuration tool bootable, healthy CPU. It may not own any CPU released with the OS product to reconfigure the or the CPUs it owns are Unhealthy (or fPar and reboot the partition. A cold reset of the deconfigured) hard partition may be required Platform Events - Table 2 (Windows System Log Event ID, Cause, Recommended Action) 115