HP Integrity rx4640 Windows Integrity Management Agents Reference - Page 97
Run DC Connectivity test. Check flex cables, Fabric AccessError. Couldn't write this XBC.
View all HP Integrity rx4640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
8966 8968 8969 8970 8971 8972 8973 8974 8975 8976 8979 8981 8982 8983 8984 9000 9019 9020 9021 Fabric AccessError. Couldn't write this XBC. Contact HP Support personnel to analyze the fabric. Probably an error reading the XIN. Look for additional descriptive chassis codes. Contact HP Support personnel to check the CC Probably an error reading the XIN. Look for additional descriptive chassis codes. Contact HP Support personnel to check the CC Hardware AccessError. Have your HP support representative check the Coherency Controller (CC). Hardware AccessError. Have your HP support representative check the backplane and Coherency Controller (CC). Ensure the cells are connected. Check historical chassis codes from most recent boot to see if the link had ever initialized. Have your HP support representative check the backplane and Coherency Controller (CC). Ensure the cells are connected. Check historical chassis codes from most recent boot to see if the link had ever initialized. Have your HP support representative check the backplane and Coherency Controller (CC). Hardware AccessError. Contact HP Support personnel to analyze the fabric, CC, Backplane. link init problem Contact HP Support personnel to check the XBC, CC, backplane An unanticipated error occurred. Contact HP Support personnel to analyze the IPMI FPL log. A CPU is broken. Replace it. The RTC was invalid No action is required. The problem has been corrected by SFW. This could be caused by an incompatibity problem between PAL and the CPUs. Check that PAL supports all the CPUs installed on the system. Look for adjacent chassis codes to determine the cause of FabricWalk failure. Check the backplane and fabric connectivity. Contact the HP Support Personnel for further troubleshooting. Most likely a failure on the fabric or on the CC. Fabric failures should produce additional chassis codes. If no additional chassis codes indicate the cause of the failure, then contact the HP Support Personnel for further troubleshooting. SFW detected a failing DIMM Replace the DIMM flagged by SFW The Cell board has a problem. Either the Real Time Clock is not working properly or the system is not being clocked at the value it thinks it is. Fabric Access Failure, Check CC to CC link. Look for additional failure chassis codes to provide more detail. link errors. Run DC Connectivity test. Check flex cables, XBCs, and CCs. Platform Events - Table 2 (Windows System Log Event ID, Cause, Recommended Action) 97