HP Integrity rx4640 Windows Integrity Management Agents Reference - Page 119
Collect IPMI Logs and contact your HP Support
View all HP Integrity rx4640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
11932 11933 11960 11961 11962 11964 11966 11967 11968 11969 11970 11971 11972 11974 11989 12001 12008 12013 12017 12025 12028 12029 12047 OS or firmware bugs Call HP support Software data corruption Call HP support Contact Engineering, This is a bug. Contact Engineering, This is a bug. Contact Engineering, This is a bug. Cell online add/delete was attempted but the colad subsystem failed to initialize. Contact HP support. When this event is emitted, cell online add/delete is not usable. FPARs component on which cell on line add/delete depends is broken or missing. Do not use COLAD is FPARs mode Cell on line add/delete in FPARs mode failed to get the FPARs semaphore. Do not use cell on line add/delete in FPARs mode. More than one processor from an FPAR called into cell on line add/delete Do not use cell on line add/delete in FPARs mode All FPARs processors failed to rendezvous during a cell on line add/delete operation. Do not use cell on line add/delete in FPARs mode New cell cannot communicate with existing partition. Cell OLA failed. Existing partition can continue to run, new cell cannot be added to the partition. For Fpars/Vpars, system FW will reset the hard partition. For npars, system FW will still attempt An MCA happened before a previous MCA event to hand off to the OS_MCA handler, if OS_MCA did not complete. handoff fails, the hard partition will get reset. For Fpars/Vpars, system FW will reset the hard partition. In Npars mode, MCA handler will An MCA event happening before a previous INIT attempt to hand off to OS_MCA handler. If event was not completely processed. handoff fails, the hard partition will be reset. The bad edge could not be found. Check for intermittent link errors. Capture IPMI event logs and look for additional error events. Contact your HP Support Representative to investigate the fabric. A soft partition could not be booted. Please refer The partition is rebooted to nPars to allow the to previous events for the complete details. soft partition to be re-configured. Capture IPMI event logs. Contact your HP A traversable route between the local cell and the Support Representative to investigate the fabric specified destination crossbar could not be found subsystem. Internal FW error. Reset partition An uncorrectable memory ECC error has occurred. Replace all DIMMs in the memory rank specified in the physical location info. If problem persists, contact HP support to troubleshoot the problem. Unexpected error retrieving information from the fabric graph. Collect IPMI event logs and contact your HP Support Representative to investigate the fabric system firmware subsystem System Firmware encountered an error while reading a fabric crossbar chip. Collect IPMI Logs and contact your HP Service Representative to investigate the fabric subsystem. System Firmware could not establish routing Collect IPMI Logs and contact your HP Support from the local crossbar that would be needed to Representative to investigate the fabric complete the route around routing. subsystem. An invalid, non supported TPM is being used in the system Contact HP for support Platform Events - Table 2 (Windows System Log Event ID, Cause, Recommended Action) 119