HP Media Center 886c HP Media Center Desktop PCs - (English) Hardware User Gui - Page 66

HP Media Center 886c Manual

Get HP Media Center 886c PDF manuals and user guides View all HP Media Center 886c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 66 highlights

Be careful of the sharp edges on the expansion slot cover. w Removing Add-In Cards 1 Disconnect any external and internal cables attached to the card. replacing. 2 Loosen the screw on the bracket of the card you are 3 Hold the metal bracket and the far top corner of the card. Carefully remove the card by pulling the card straight out of the expansion slot. Do not overload the PC by installing add-in cards that draw excessive current. The chassis is designed to provide 2 amps (average) of +5 V power for each board or card in the chassis. The total +5 V current draw in a fully loaded chassis (one with all add-in card slots filled) must not exceed the total number of slots multiplied by 2 amps. w Replacing Add-In Cards 1 Insert the new card into the slot and push straight down. Make sure the card is properly seated. replaced. 2 Attach the screw to secure the card you have 3 Connect any internal cables to the card. 58

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
58
Removing Add-In Cards
1
Disconnect any external and internal cables attached
to the card.
2
Loosen the screw on the bracket of the card you are
replacing.
3
Hold the metal bracket and the far top corner of the
card. Carefully remove the card by pulling the card
straight out of the expansion slot.
Replacing Add-In Cards
1
Insert the new card into the slot and push straight
down. Make sure the card is properly seated.
2
Attach the screw to secure the card you have
replaced.
3
Connect any internal cables to the card.
w
Be careful of the
sharp edges on
the expansion
slot cover.
w
Do not overload
the PC by
installing add-in
cards that draw
excessive current.
The chassis is
designed to
provide 2 amps
(average) of +5 V
power for each
board or card in
the chassis. The
total +5 V current
draw in a fully
loaded chassis
(one with all
add-in card slots
filled) must not
exceed the total
number of slots
multiplied by
2 amps.