HP OmniBook 600C fw 02.00.02-1 and sw 06.00.02 HAFM Server Omnibook - Installa - Page 19
Windows 2000 Setup and Configuration, Power Options, Changing the Default Power Options - files
View all HP OmniBook 600C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
4 Windows 2000 Setup and Configuration To install and operate HAFM on the HP Omnibook 6000/6200 PC, Windows 2000 must be installed. Windows 2000 is not factory installed on the HP Omnibook 6200 PC. To install Windows 2000, use the HP System Recovery CDs that come with the PC. See the README.TXT file on Disk 1 of these CDs for specific instructions on performing a factory installation. Note that the PC comes with recovery CDs for both Windows NT Workstation 4.0 (single CD) and Windows 2000 Professional (two CDs). Use the System Recovery CD for Windows 2000 Professional (the dual CD set). Because this process requires the use of a CD-ROM drive, replace the internal Zip drive with an internal CD-ROM drive prior to performing the installation. Power Options The default power options selected during the Windows 2000 installation allow the system to enter standby and hibernate modes after a period of inactivity. Change these defaults to prevent the PC from ever entering either of these modes by selecting a pre-defined power scheme that never allows the system to enter standby or hibernate modes. Changing the Default Power Options To change the default power options, complete the following steps: 1. Choose Start > Settings > Control Panel. The Control Panel window displays. 2. Double-click Power Options. The Power Options Properties dialog box displays, as shown in Figure 4-1. HAFM server installation guide 4-1