HP OmniBook xe3-gc HP OmniBook Notebook PC XE3 Series - Reference Guide - Page 136

Specifications and Regulatory Information Modem Reference Information Command A/ A B0 B1 C1 Dn E0 E1 H0 H1 I0 I1 I2 I3 I4 I5 I6 I7 L0 L1 L2 L3 M0 M1 M2 M3 N0 N1 O0 O1 P Q0 Q1 Sn Sn? Sn=v T V0 V1 W0 Modem Reference (Ambit) AT Commands (Ambit) In the following AT command table, default settings are shown in bold. All listed AT commands except A/ must be preceded by "AT." Function (Ambit) Re-execute command (not preceded by AT) Go off-hook and attempt to answer a call Select V.22 connect @1200 bps Select Bell 212A connect @1200 bps Return OK message Dial modifier Turn off command echo Turn on command echo Initiate a hang-up sequence If on-hook, go off-hook and enter command mode Report product code Report pre-computed checksum Report "OK" if the calculated checksum equals the prestored checksum or if the prestored checksum value is FFh Report firmware revision, model, and interface type Report response programmed by OEM Report the country code parameter Report modem data pump model and code revision Report the DAA code Set low speaker volume Set low speaker volume Set medium speaker volume Set high speaker volume Turn speaker off Turn speaker on during handshaking and turn speaker off while receiving carrier Turn speaker on during handshaking and while receiving carrier Turn speaker off during dialing and receiving carrier and turn speaker on during answering Turn off automode detection Turn on automode detection Go on-line Go on-line and initiate a retrain sequence Force pulse dialing Allow result codes to DTE Inhibit result codes to DTE Select S-Register n as default Return the value of S-Register n Set default S-Register n to value v Force DTMF dialing Report short form result codes Report long form result codes Report DTE speed only 136 Reference Guide