HP ap5000 Maintenance and Service Guide: HP ap5000 All-In-One Point of Sale Sy - Page 59

Removing and Replacing the Hard Drive

Get HP ap5000 - All-in-One Point of Sale System PDF manuals and user guides View all HP ap5000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

Removing and Replacing the Hard Drive CAUTION: Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. 1. Turn off the computer properly through the operating system, then turn off any external devices. 2. Disconnect the power cord from the power outlet. CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer. 3. Remove the drive cover (see Removing the Drive Cover on page 43). 4. Grasp the plastic tab attached to the hard drive and pull the hard drive out of the bay, Figure 7-15 Removing the Hard Drive Removing and Replacing the Hard Drive 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
Removing and Replacing the Hard Drive
CAUTION:
Before you remove the old hard drive, be sure to back up the data from the old hard
drive so that you can transfer the data to the new hard drive.
1.
Turn off the computer properly through the operating system, then turn off any external devices.
2.
Disconnect the power cord from the power outlet.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
3.
Remove the drive cover (see
Removing the Drive Cover
on page
43
).
4.
Grasp the plastic tab attached to the hard drive and pull the hard drive out of the bay,
Figure 7-15
Removing the Hard Drive
Removing and Replacing the Hard Drive
51