HP dx7510 Service Reference Guide: HP Compaq dx7510/dx7518 Business PC - Page 19
Computer Setup—Hardware Monitor Setup, Computer Setup-PnP/PCI Configurations continued
View all HP dx7510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Table 2-8 Computer Setup-PnP/PCI Configurations (continued) Reset Configuration Data Disables/enables automatic reconfiguration. The default is Disabled. Select Enabled to reset Extended System Configuration Data (ESCD) when you exit Setup, if you have installed a new add-on and the system reconfiguration has caused such a serious conflict that the OS cannot boot. Resources Controlled By Allows you to select whether resources are controlled automatically or manually: ● Auto (ESCD-Extended Storage Configuration Data) ● Manual BIOS can automatically configure all the bootable and Plug-and-Play-compatible devices. If you choose Auto, you cannot select IRQ, DMA and memory base address fields since BIOS automatically assigns them. IRQ Resources ● IRQ-3 assigned to ● IRQ-4 assigned to ● IRQ-5 assigned to When resources are controlled manually, allows you to assign each system interrupt a type, depending on the type of device using the interrupt. Legacy ISA for devices compliant with the original PC AT bus specification, PCI/ISA PnP for devices compliant with the Plug-and-Play standard whether designed for PCI or ISA bus architecture. ● IRQ-7 assigned to ● IRQ-9 assigned to ● IRQ-10 assigned to ● IRQ-11 assigned to ● IRQ-12 assigned to ● IRQ-14 assigned to ● IRQ-15 assigned to Computer Setup-Hardware Monitor Setup NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 2-9 Computer Setup-Hardware Monitor Setup Option Description Reset Case Open Status Fan Controller CPU Fan Speed Disables/enables resetting of the case open status. Disables/enables auto fan control mode. (view only) System Fan Speed (view only) CPU Fan Fault Detect Disables/enables detection of CPU failure during POST. SYS Fan Fault Detect Disables/enables detection of fan failure during POST. Computer Setup (F10) Utilities 11