Honeywell NX4S1 User Guide - Page 44
Configuration > Doors > Reader Tab Descriptions, Setting, Description
View all Honeywell NX4S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Configuring via the Web Server Configuring the System Table 2-4: Configuration > Doors > Reader Tab Descriptions Setting Description Anti-Passback Configures the anti-passback feature, which prevents an entrant to an area from passing his card back to another potential entrant. Note that anti-passback must first be enabled at the Configuration > System > General screen (see General Tab, page 14). Enabled - Enables the anti-passback feature. Hard - Does not allow a second entry on the same card without an exit; validates in/out status before allowing entry. Soft - Allows entry on the same card without an exit; however, an event is generated that indicates violation. Out - Applies to readers located inside the area. Cardholders use these readers when attempting to exit the area. In - Applies to readers located outside the area. These are readers that cardholders use when attempting to enter the area. Duress Output Configures the output that will trip when a cardholder enters a "duress PIN" at a keypad/card reader. A duress PIN is the PIN a user enters at a keypad when being forced (perhaps in a robbery) to open a door. The user enters his normal PIN, except one of the digits is one number higher or lower than the normal digit. This PIN opens the door, but it also triggers the designated duress output and produces an alarm. The duress output feature requires the following: • "Duress" must be enabled on the Configuration > System > General tab. • A time zone must be selected for "Card and PIN" on the Configuration > Doors > Reader tab. 2. Click Card Formats at the side of the tab. A card format tells the panel how the card number will be read. The panel supplies the format to the card readers. Then, the card readers can correctly read the card. 34 www.honeywell.com