Honeywell NX4S1 User Guide - Page 64
Table 2-10, Configuration > Other I/O & Groups > Inputs Tab Field Descriptions
View all Honeywell NX4S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Configuring via the Web Server Configuring the System Steps: Use the descriptions in the following table to configure other panel inputs and downstream inputs: Table 2-10: Configuration > Other I/O & Groups > Inputs Tab Field Descriptions Setting Description Name Enter a unique name to identify the device. Mode Normally Closed - Specifies that the door's normal state is closed. Normally Open - Specifies that the door's normal state is open. Unsupervised - Specifies that the door's electrical circuit is wired in one path without alternative paths supervised by resistors. Supervised - Specifies that the door's electrical circuit is wired with alternative paths supervised by resistors. Shunt Time Specifies the amount of time for which the inputs will be shunted, or de-activated. The maximum number of hours is 1. When the hour field is blank, the maximum number of minutes is 59. When 1 is entered in the hour field, the maximum number of minutes is 45. The sum of all three units comprises the shunt time. Note that you can express seconds in tenths of a second. Debounce Time Specifies the period of time the input must remain in a new state before generating an alarm. For example, if a Normal state is changed to Alarm, the state must remain in Alarm for five seconds before an alarm is generated. Time Zones Shunt - Specifies the time period during which the input will be shunted. Disable Interlock - Specifies the time period during which the programmed action on this input from another point will be disabled. Disable Alarm Msgs - Specifies the time period during which the input will generate no alarms. Auto-Relock Causes the door to re-lock immediately when the door status switch closes after entry. The output relay that controls the door strike de-energizes when the associated input returns to normal state instead of remaining energized for the duration of the pulse time. To enable Auto-Relock, de-select the Disable checkbox, and select the associated output from the drop down list. 54 www.honeywell.com