Icom M802 Instruction Manual - Page 29

7 CALL PROCEDURE I Distress call to ships General DSC call with the "distress" category may be used for communications after the Distress call, e.g. you want to change the operating mode, frequency, etc. The call is transmitted one time only although the distress call using the [DISTRESS] switch sends 5 times repeatedly. D Operation outline RX 12.345.0 J3E GPS Lat 34 34'N SP Lon135 34'E 12:34 Exit DSC menu ******* DSC MENU ******* -------- Select -------- Position ÇIndividual Group All ships Position REQ Distress Test RX memory TX memory Set up Exit SEL OK Address ID selection ****** Individual ****** ------ Address ID ------ ÇManual set IC-M802-1 123456789 IC-M802-2 123456788 IC-M802-3 123456787 IC-M802-4 123456786 IC-M802-5 123456785 SEL OK Manual ID input ****** Individual Address ID ------ 987654321 OK Category selection ****** Individual Category ------- Routine Safety Urgency ÇDistress SEL OK 1st telecommand selection ****** Individual ****** --- 1st telecommand ---ÇJ3E No information 7 SEL OK Traffic frequency selection 1 ****** Individual ****** -- Traffic frequency --ÇManual set T: 4567.0kHz R: 4567.0kHz T:12345.0kHz R:12345.0kHz SEL OK IC-M802-1 IC-M802-2 Traffic frequency selection 2 ****** Individual ****** -- Traffic frequency --- TX:_2134.0kHz RX:_2134.0kHz SEL OK Call frequency selection ****** Individual ****** ---- Call frequency ---- Ç 2187.5kHz 4207.5kHz 6312.0kHz 8414.5kHz 12577.0kHz 16804.5kHz SEL OK Call stand-by screen Push [CANCEL/CALL] for 1 sec. to start calling. Push [ENT] for 1 sec. to store the condition into a TX memory channel. ****** Individual ****** --------- Call --------- Category:Distress To:987654321 Traffic:J3E TX 2134.0kHz RX 2134.0kHz Call Freq:TX 2187.5kHz RX 2187.5kHz Call Write-Menu 21