Icom M802 Instruction Manual - Page 30

7 CALL PROCEDURE D Operation for distress call to ships q Push [DSC] to select DSC watch mode. w Push [MODE SET] to select the DSC menu. [DSC] [MODE SET] [ENT] [CANCEL/CALL] [CH] [F] [FREQ/CH] e Rotate [CH] to select "Individual," then push [ENT]. r Rotate [CH] to select "Distress," then push [ENT]. ****** Individual Category ------- Routine Safety Urgency ÇDistress SEL OK t Rotate [CH] to select the desired pre-programmed ID, or "Manual set," then push [ENT]. ✔When pre-programmed ID is selected, go to step u. ****** Individual ****** ------ Address ID ------ ÇManual set IC-M802-1 123456789 IC-M802-2 123456788 IC-M802-3 123456787 IC-M802-4 123456786 IC-M802-5 123456785 SEL OK y Enter the desired 9-digit MMSI code via the keypad. ✔ The number "0 (zero)" cannot be entered for the 1st digit, as the 1st digit "0" means group code. ****** Individual Address ID ------ 987654321 OK u Rotate [CH] to select 1st telecommand, then push [ENT]. ✔ When "No information" is selected, go to step !0. ****** Individual ****** --- 1st telecommand ---ÇJ3E No information i Rotate [CH] to select the desired pre-programmed traffic frequency, or "Manual set" then push [ENT]. ✔ When pre-programmed traffic frequency is selected, go to step !0. ****** Individual ****** -- Traffic frequency --ÇManual set T: 4567.0kHz R: 4567.0kHz T:12345.0kHz R:12345.0kHz SEL OK IC-M802-1 IC-M802-2 o Enter the desired transmit and receive traffic frequency via the keypad, then push [ENT]. ****** Individual ****** -- Traffic frequency --- TX:_2134.0kHz RX:_2134.0kHz SEL OK !0 Rotate [CH] to select the desired calling frequency, then push [ENT]. ****** Individual ****** ---- Call frequency ---- Ç 2187.5kHz 4207.5kHz 6312.0kHz 8414.5kHz 12577.0kHz 16804.5kHz SEL OK !1 The call stand-by screen is displayed as follows, verify the calling condition then push and hold [CANCEL/CALL] for 1 sec. to start calling. ****** Individual ****** --------- Call --------- Category:Distress To:987654321 Traffic:J3E TX 2134.0kHz RX 2134.0kHz Call Freq:TX 2187.5kHz RX 2187.5kHz Call Write-Menu !2 After the call, wait for an acknowledgement call. • The calling is performed one time only. Individual < Wait for ACK > RX J2B GPS Lat 34 34'N SP Lon135 34'E 12:34 Exit SEL OK 22