JVC GY-HM600U GY-HM600U Instruction Manual (135 pages) - Page 103
Test Tone, Mic Wind Cut, Equalizer, Monitor, Alarm Level, Audio On FULL AUTO
View all JVC GY-HM600U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Menu Display and Detailed Settings Test Tone For specifying whether to output the audio test signals (1 kHz) during color bar output. [Setting Values: On, ROff] Mic Wind Cut For selecting whether to cut the low frequencies of the audio input signals (low-cut) when the [INPUT1/ INPUT2] switch is set to "MIC" or "MIC+48V". Set this item to reduce wind noise from the microphone. 0 Both: Enables low-cut on both the [INPUT1] and [INPUT2] terminals. 0 INPUT2: Enables low-cut on the audio of the [INPUT2] terminal only. 0 INPUT1: Enables low-cut on the audio of the [INPUT1] terminal only. 0 Off: Disables low-cut. [Setting Values: Both, INPUT2, INPUT1, ROff] Int. Mic Wind Cut For selecting whether to cut the low frequencies of the audio input signals (low-cut) from the built-in microphone. Set this item to "On" to reduce wind noise from the microphone. [Setting Values: On, ROff] Equalizer You can correct the characteristic and enhance the sound of the connected microphone using this equalizer setting. For setting the audio frequency from a 5-band equalizer. 0 Frequency: 100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz 0 Variable level: ± 6dB (1dB step) Memo : 0 Audio will be recorded in the characteristic set in the equalizer. 0 Set all bands to "0dB" to bypass the equalizer. 0 When the equalizer level is set to +side, the audio may be distorted. In this case, reduce the recording level in Manual mode. 0 If the values of multiple frequencies are changed, the specified levels and the actual levels may be different due to interference between the frequency bands. 0 This function is enabled only when both [Mic Wind Cut] and [Int. Mic Wind Cut] are set to "Off". Monitor For setting the audio sound of the [x] terminal to stereo or mixed sound when the [MONITOR] switch on the LCD monitor is set to "BOTH". 0 Mix: Outputs mixed sound (mixed sound of CH1 and CH2) to both L and R. 0 Stereo: Outputs stereo sound (outputs audio sound of CH1 to L, and CH2 to R). [Setting Values: RMix, Stereo] Memo : 0 If both CH1 and CH2 are built-in microphones, stereo sound is output from the [x] terminal regardless of the [Monitor] setting. Alarm Level For selecting whether to turn on the warning tone as well as setting the volume. The warning tone is output from the monitor speaker or [x] terminal. [Setting Values: RHigh, Middle, Low, Off] Audio On FULL AUTO For setting whether to enable Auto for audio when [FULL AUTO] is set to "ON". 0 SW Set: Sets the audio recording mode following the [CH1/CH2 AUTO/MANUAL] selection switch setting. 0 Auto: Sets audio recording mode to the forced auto mode. [Setting Values: SW Set, RAuto] 103