JVC SR-VD400US Instruction Manual - Page 61
Notes, S-vhs Et, Display
View all JVC SR-VD400US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Ⅵ S-VHS ET ON OFF Ⅵ DISPLAY ON OFF EN 61 * The default setting is bold in the table below. This function allows you to record on VHS tapes with S-VHS picture quality. Tapes recorded using this function can be played back on a VCR equipped with the S-VHS ET function. The S-VHS indicator lights up on the front display panel when "S-VHS ET" is set to "ON". NOTES: ● Before recording, make sure that "V. CALIBRATION" is set to "ON" (੬ pg. 56). ● You cannot activate the S-VHS ET function... - while recording is in progress. - while timer-recording or Instant Timer Recording (੬ pg. 28) is in progress. - while Video Calibration (੬ pg. 56) is in progress. ● S-VHS ET does not work with S-VHS tapes. ● To keep the highest quality recording and playback pictures over a long period of time, S-VHS recording on S-VHS tapes is recommended. ● Use of high grade tapes are recommended for S-VHS ET recordings. On some tapes, picture quality will not improves even if the S-VHS ET function is used. Check the recording quality before you start important recordings. ● You can play back S-VHS ET recordings on most of S-VHS VCRs and of VHS VCR equipped with SQPB (S-VHS QUASI PLAYBACK) function. (Notice some VCRs are not compatible with this function.) ● While playing back a tape recorded with this function on some tapes, noise may appear. (If playback picture becomes blurred or interrupted, use a cleaning cassette.) ● During special effect playback (੬ pg. 31), noise may appear. If special effect playback is performed frequently on a tape recorded with this function, the tape may be damaged and picture may be deteriorated. When this function is set to "OFF", only ":" appears on the front display panel. NOTE: Even if you set "DISPLAY" to "OFF", each item appears on the front display panel in the following cases; ● when the timer-recording is in progress/in the timer standby mode (੬ pg. 34 - 41) ● in the satellite Auto Recording standby mode (੬ pg. 64) ● during Plug & Play setting (੬ pg. 9) ● when you press REC ( ¶ ) twice for the ITR (੬ pg. 28) ● when you set the remote control code (੬ pg. 73) ● when you press DISPLAY, the current status appears for a few seconds.