JVC SR-VD400US Instruction Manual - Page 72
DBS Receiver Brand Setting
View all JVC SR-VD400US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
72 EN MULTI-BRAND REMOTE CONTROL (cont.) DBS Receiver Brand Setting 2 VCR CABLE TV /DBS 3 - 2 4 Number keys 3 - 1,3 4 4 TV/VCR CH +/- ENTER 3 - 3 When programed (set) with a manufacturer's (brand's) code, this Remote can perform some of the remote control functions of the listed DBS (Direct Broadcast Satellite) receivers. 1 Turn on the DBS receiver Turn on the DBS receiver using the Power button on the DBS receiver or its Remote. 2 Set remote operation mode Set the VCR/TV/CABLE/DBS selector to "CABLE/ DBS". 3 Enter DBS receiver brand code Follow the example shown below. 1 Press and hold POWER. 2 Press the Number keys to enter your DBS receiver's brand code by referring to the table below. 3 Press STOP ( 7 ), and release POWER. ● Once you have set the Remote to operate a DBS receiver, you do not have to set it again until you replace the Remote's batteries. 4 Operate DBS receiver Press one of the following buttons: POWER, TV/ VCR CH +/-, and Number keys. ● For some brands, you must press ENTER after having pressed the Number keys to enter a channel number. ● To change the DBS receiver's channels, press TV/VCR CH +/- or the Number keys. ● To operate the VCR, set the VCR/TV/CABLE/ DBS selector back to "VCR". DBS BRAND NAME JVC (DISH Network) ECHOSTAR (DISH Network) SONY (DSS) RCA (DSS) BRAND CODE 51 51 41 40 NOTES: ● Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote. ● It is impossible to control a DBS receiver that does not have a remote sensor. ● It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time. (Ex.) To set the Remote to JVC 51: POWER JKL . , ? STOP Hold down Press in succession Release