JVC SR-VD400US Instruction Manual - Page 67
Make connections, Load a cassette, Select input location on this VCR, Set recording speed
View all JVC SR-VD400US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
1 Make connections A Connection with the camcorder Connect a DV cable between the camcorder's DV connector and your VCR's DV IN connector. B Connection with the VCR Connect an i.LINK cable between the playback VCR's i.LINK input/output connector and the recording VCR's i.LINK input/output connector. NOTES: ● Depending on the devices equipped with the i.LINK connector which is connected to the VCR, picture noise on this VCR may differ from the noise on the connected devices. It is caused by the difference of the data processing method. ● Connection with certain product(s) may not be supported. (੬ "ATTENTION" on the back cover.) 2 Load a cassette Insert the cassette to be recorded on into this VCR (for recording). 3 Select input location on this VCR On the front panel: Press CHANNEL +/- to select "I-1 etc.". On the Remote: Press TV/VCR CH +/- to select "I-1 etc.". 4 Set recording speed Press REC SPEED to set the recording speed. ● For more details, refer to "About Recording Speed" below. EN 67 5 Start playback Press PLAY ( 3 ) on the connected device. NOTE: If the connected device is equipped with a superimpose/OSD disable feature then set it to "OFF" before starting playback. 6 Start recording On the front panel: Press REC ( ¶ ). On the Remote: Press REC ( ¶ ) and PLAY ( 3 ) at the same time. NOTE: If "108 REC BY HS MODE" appears on the TV screen, refer to "Error Codes and Messages" on page 79. Do not connect this VCR to the PC with the i.LINK cable. The operation is not guaranteed. About Recording Speed Input Source (Playback device) i.Link/ DV input D-VHS DV camcorder Others Selectable Recording Speed (Recording device: This VCR) Auto (HS/STD/LS3/LS5)*, HS, STD, LS3, LS5 HS, STD, LS3, LS5 Auto (HS/STD)*, HS * Auto mode: The recording speed will be selected automatically according to the amount of data input (the transfer rate) from the i.LINK connector. NOTES: ● When dubbing using the i.LINK connector, set the recording speed on the recording VCR to the same speed as the source tape on the playback VCR. ● When "AUTO" is selected for the recording speed, "AUTO" and the selected speed appear on the front display panel in turn.