Konica Minolta C83hc High Chroma AccurioPress C6100/C6085 AccurioPress C3080/C - Page 19

Notice

Get Konica Minolta C83hc High Chroma PDF manuals and user guides View all Konica Minolta C83hc High Chroma manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

2.2 Checking the Automatic Inspection Level 2 5 Check the automatic inspection report. Check the report following the procedure described in "4.1 Confirming the Automatic Inspection Report" in this manual. Check whether the levels specified in step 2 match the values framed in red. NOTICE The result of automatic inspection may vary depending on whether any subtle changes are made for each print job. Perform automatic inspection three to five times and then judge the combined results. 6 If adjustment is required, repeat steps 2 to 5. NOTICE Visibility may differ between the actual output original and the automatic inspection test chart. If necessary, configure settings again in [Auto Inspection Level Detailed Setting]. Automatic Inspection Operation Manual 2-12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
Automatic Inspection Operation Manual
2-12
2.2
Checking the Automatic Inspection Level
2
5
Check the automatic inspection report.
Check the report following the procedure described in "4.1 Confirming the Automatic Inspection Re-
port" in this manual. Check whether the levels specified in step 2 match the values framed in red.
NOTICE
The result of automatic inspection may vary depending on whether any subtle changes are made for
each print job. Perform automatic inspection three to five times and then judge the combined results.
6
If adjustment is required, repeat steps 2 to 5.
NOTICE
Visibility may differ between the actual output original and the automatic inspection test chart. If neces-
sary, configure settings again in [Auto Inspection Level Detailed Setting].