Konica Minolta Fujitsu ScanSnap S1300i Operation Guide - Page 22
Parts and Functions, Front
View all Konica Minolta Fujitsu ScanSnap S1300i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Parts and Functions Parts and Functions This section explains names and functions of the ScanSnap parts. ■ Front ADF paper chute (cover) (*) Open to use the ScanSnap. D Opening the ADF paper chute (cover) turns on the ScanSnap. ADF top section Open to remove jammed documents, replace the pad assy and the pick roller, or clean the inside of the ScanSnap. Extension Pull out when scanning long documents. ADF paper chute (cover) You can load the document here after opening it. Side guide Adjust to the width of documents to prevent them from getting skewed. ADF release tab Pull this tab to open the ADF top section. [Scan] button (*) Press this button to start scanning. It indicates the status of the ScanSnap as follows: Blue (lit) : Ready Blue (flashing) : Scanning Orange (flashing) : Error * : When the ScanSnap has turned off automatically, either press the [Scan] button, or close the ADF paper chute (cover), then open it again to turn the ScanSnap back on. Note that pressing the [Scan] button when the ScanSnap is turned off will not start scanning. For details, refer to "ScanSnap's auto power off" (page 30). 22