Konica Minolta Kodak Scan Station 710 Administration Guide - Page 121
Replacing the feed module and tires, position. Be sure the gears are aligned and it snaps into place
View all Konica Minolta Kodak Scan Station 710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Replacing the feed module and tires NOTE: The paper present sensor is located to the left of the feed module. Be careful not to damage the paper present sensor when removing or cleaning around the feed module. 1. Pull against the raised edge of the feed module cover and lift it up and out of position. 2. Rotate the feed module forward and push it to the left to lift it out of position. • If you are replacing the feed module, insert the new feed module by aligning the pins and pushing it toward the left to fit it into position. Be sure the gears are aligned and it snaps into place, then go to Step 8. • If you are replacing the tires, continue with Step 3. 3. Remove one core assembly by lifting up and out of position. 4. Remove each tire by sliding the tire off the core. 10-10 A-61796 December 2013