Kyocera KM-4850w KM-4850W Operation Guide Rev-8 - Page 86
accessed. See List of Default Setting.
View all Kyocera KM-4850w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
CHAPTER 8 TROUBLESHOOTING Message "No roll unit" ["Roll unit is not set."] "Add Paper in X Drawer." "Check waste toner tank." "Add toner." "Time for Maintenance" "Call service." "Memory full" "Could not be saved." "Exceeding zoom range. Reenter zoom ratio." "These functions cannot be combined." "Incorrect pin code." ["Incorrect ID-Code."] "Repeat copy code is wrong." "Insert key counter." Countermeasures A roll unit is not securely inserted. Open the front cover and push the roll unit in securely. Paper with different width is set for interrupt copy or job reserve. Replace the paper roll. The waste toner tank is full or the tank is not properly installed. Replace it with a new tank or install the tank properly. Page 3-6 3-6 8-5 If this message is displayed with "Ready to copy.", copying can be performed but continuous copying is not possible. Replen- 8-3 ish toner promptly. Copying can be performed for some time but when only this message is displayed, copying cannot be performed. Maintenance of the machine is needed. Contact your service - representative. A problem has occurred inside the main body. See 8-8 "5. Countermeasures against Call for service Message". Memory overflow has occurred. See "4. Countermeasures against Memory Overflow." 8-6 Original images cannot be saved in memory. Copying of second original and after or repeat copy cannot be performed. 8-6 See "4. Countermeasures against Memory Overflow." The magnification ratio or another setting for editing functions - exceeds the specified limit. Press the OK key and then enter the value again. A function or a default setting that cannot be set now is 7-1 accessed. See "List of Default Setting". The password is not correct. Use the numeric keys to enter the correct password. 7-3 The repeat copy code is not correct. Use the numeric keys to 7-6 enter the correct code. The key counter (option) is not set or not properly set. Set the counter properly. 4-1 8-2