Kyocera KM-4850w KM-4850W Operation Guide Rev-8 - Page 98

CHAPTER 8 TROUBLESHOOTING 7. Troubleshooting Refer to the following chart if trouble occurs. If trouble persists, contact your service representative. TROUBLE CHECK POINT The main power switch is on but nothing is displayed on the operation panel. Is the power plug inserted securely into the outlet? PROCEDURE Insert the power plug securely into the outlet. PAGE - The original is set, but a copy is Is there a message on the Check the proper procedure for the displayed not made. operation panel? message and perform accordingly. 8-1 The copy is blank. Was the original inserted face Insert the original face down. down? 3-2 Paper jams often. Are there wrinkles or folds in the paper? Remove the portion of the paper roll that contains the wrinkles or folds. 8-12 Copy image is skewed. Is there any jammed paper or Remove them by following the appropriate procedure. are there other pieces of paper 8-9 remaining inside the machine? Is the paper setting method Check the paper setting method. proper? 3-6 Is vellum used? The leading edge may have been damaged. Pull out the paper roll until the damaged portion - comes out and then cut it before using it. Was the original fed straight? Set the original referring to "q Setting the original with precision". 3-3 Is inclination adjustment set? Disable the inclination adjustment. 6-1 Copy image is shifted to either Are the original guides properly Align the original guides with the original size side (widthwise) set in accordance with the indications and then insert an original. original size indications on the 3-2 original table? Is the paper roll installed properly into the roll unit? Align the flange guide positions with the appropriate size labels. 3-6 8-14 Was the paper fed properly in Adjust the bypass guides to the paper size and then the bypass mode? insert the copy paper. 4-8 Was the image shift function Cancel the image shift function. set? 5-5