Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 112
Horizontal band, Check print head temperature, Clog up nozzle correction
View all Kyocera TASKalfa Pro 15000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Troubleshooting > Troubleshooting When Printing Image 4 Select [Start]. After the pattern is scanned, the number of clogged nozzles of each color is displayed. If there is even one clogged nozzle, go to the next step. 5 [Stop] key > select [01 Cleaning]. 6 Select the color which has clogged nozzles > select [Strong] as the strength of cleaning > [Start] key. The head cleaning begins. 7 If the nozzle clog is not solved using head cleaning three times, change the strength of cleaning to [Ex Strong] and execute cleaning three times. 8 If the nozzle clog is not solved, go to the next step. 3 Check print head temperature When [U735 Set Ink Temperature Control] is selected as the print priority mode, printing is possible even in a low-temperature environment (up to 22°C/71.6°F), so the nozzles may become clogged due to an increase in ink viscosity. 1 [Home] key > [...] > [Professional Settings] > [U735 Set Ink Temperature Control] 2 Confirm that [01 Mode] is set to [Printing]. 3 If so, change the mode to [Quality] > [Start] > [Stop] key. NOTE If [Quality] is selected, printing will not start until the print head temperature is 26.1 ° C/ 78.98°F or higher. 4 If the mode is [Quality] and the problem is not solved, go to the next step. 4 Clog up nozzle correction Nozzle Correction (Chapter 18) in Operation Guide In case that no improvement is observed, contact your dealer or service representative. Horizontal band Void Band Hindering the path by jammed paper 1 Check if the jammed paper is still on the paper path and remove it if it is found To remove the jammed paper under the print head, refer to following. Clearing Paper Jam under Print Head (page 4-45) 4-9