Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 148
Troubleshooting When Feeding Paper, Clearing Paper Jam under Print Head
View all Kyocera TASKalfa Pro 15000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Troubleshooting > Troubleshooting When Feeding Paper Troubleshooting When Feeding Paper Clearing Paper Jam under Print Head When the paper jam under the print head occurs, the following message appears. "System error. 7940" Follow the steps below to clear the jammed paper, and clean the image conveying belt to prevent ink stains on the back of the paper in the following print. IMPORTANT When clearing paper jam under the print head, prepare the following. • Rubber gloves • Screw driver • Kim towel white or BEMCOT • Designated deionized water 1 Turn off and on the main power switch IMPORTANT When turning off the power switch, do not turn on it again immediately. Wait more than 5 seconds, and then turn on the main power switch. After powering on the machine, a jam code "J0010" appears. 2 Press [Status/Job Cancel] key to confirm the jam location 3 Wear the rubber gloves 4 Look at the jam guidance on the operation panel to clear the jammed paper under the print head and CIS regist section 5 [Home] key > [...] > [Professional Settings] > [U740 Setup] > [06 Feed Belt] > [02 Execute] > [Start] key "E0070" appears on [01 STEP]. Conveying belt goes to removal position. 6 When "AUTO0700" appears on [01 STEP], [02 Execute] > [Start] key The image conveying belt moves to the original position, and head cleaning starts. 7 After "Power off" is displayed on the operation panel, turn off the power switch 4-45