Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 137
Check setting, Check media setting, Execute print head cleaning, Mode 1
View all Kyocera TASKalfa Pro 15000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Troubleshooting > Troubleshooting When Printing Image 1 Check setting U760 Set color bleed mode is not available. The condition where one color adjacent to the other penetrates the other and becomes blurry due to bleeding is called "color bleed". Adjust the boundary gap to improve color bleed. The percentage of bleeding varies depending on the type of paper, so adjust the gaps between the colors even if white spots appear at the boundaries between the colors. Boundary gap 1 [Home] key > [...] > [Professional Settings] > [U760 Set Color Bleeding]. 2 Select an item to adjust > [Start] key The items to adjust are as follows. Item Description 01 Off Color bleed is not adjusted. 02 Mode 1 Make the gap at the boundary wider. 03 Mode 2 Make the gap at the boundary narrower. 3 In case that no improvement is observed, then go to next step. 2 Check media setting Media Type and Media Weight (Chapter 15) in Operation Guide In case that no improvement is observed, then go to next step. 3 Execute print head cleaning Landing point is shifted because of high viscosity. 1 Load SRA3/Ledger size paper. 2 [Home] key > [...] > [Professional Settings] > [U744 Head Cleaning] > [02 Check] A nozzle check pattern is printed. 3 Align the mark on the chart arrow with the mark on the upper left corner of the platen glass. As shown in the illustration, place the pattern on the glass platen with the printed side down and the edge with the arrows toward the back. 4-34