Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 134
Dirty print out, When white bands occur in the middle of a print job, confirm
View all Kyocera TASKalfa Pro 15000c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Troubleshooting > Troubleshooting When Printing Image 2 Select [02 On] or [03 On(Width>SRA3)]. When selecting [02 On], if the paper width is larger than that of the previous job (but SRA3 width or less), the machine determines whether to perform automatic head cleaning. When selecting [03 On(Width>SRA3)], if the paper width is larger than that of the previous job (and larger than SRA3 width), the machine determines whether to perform automatic head cleaning. 3 [Start] > [Stop] key > [04 Interval(Width)] 4 Select the time interval > [Start] key. You can select [10min], [20min], and [30min] as the time interval. 5 If the mode is [Quality] and the problem is not solved, go to the next step. 2 When white bands occur when starting the first print of a job, configure the ink discharge timing 1 [Home] key > [...] > [Professional Settings] > [U736 Set Waste Paper] > [01 Ink Discharge] > [02 Job Start] > [Start] key. 3 When white bands occur in the middle of a print job, confirm whether any color is set to [On] in [U734 Set Paper Discharge Mode] 1 [Home] key > [...] > [Professional Settings] > [U734 Set Paper Discharge Mode] > [01 CMY] or [02 K] > [On] > [Start] key 4 In case that no improvement is observed, configure the ink discharge timing 1 [Home] key > [...] > [Professional Settings] > [U736 Set Waste Paper] > [01 Ink Discharge] > [02 Job Start] > [Start] key > [Stop] key. 2 Select [02 Specific Interval]. 3 Select the interval any one of the [01 Mode1] (40) to [03 Mode3] (400) The number in parentheses is the interval (images) at which ink ejection starts. 4 In case that no improvement is observed, contact our service representative. Dirty print out 1 Adjust print margin 1 [Home] key > [...] > [Professional Settings] > [U402 Adjust Print Margin] 2 Adjust the setting value using [+], [-] key and numeric keypad, within the range of 2 to 4 mm. 3 Press the [Start] key > [Stop] key. In case that no improvement is observed, then go to next step. 4-31