Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 163

Troubleshooting > Troubleshooting When Discharging Paper 3 Press the [Start] key > [Stop] key. Remedy 2: Adjusting the position of the front or back staple 1 [Home] key > [...] > [Professional Settings] > [246 Adjust Finisher] > [01 Finisher] > [16 Front Bind Staple] or [17 Back Bind Staple] 2 Adjust the setting value using [+], [-] key and numeric keypad. The range of the set value is as follows. Item 16 Front Bind Staple 17 Back Bind Staple Range -30 to 30 -30 to 30 Default 0 0 Amount of change 0.19 mm 0.19 mm 3 Press the [Start] key > [Stop] key. The paper is discharged without the edges being aligned When outputting the multi-page printouts to the finisher, the first and second sheets are saved to the drum in the finisher until the third sheet is transferred to shorten the discharge time. At the timing when the third sheet is transferred to the Save drum, third sheet is sent to the finishing section together with the first and second sheets, and the edges of the sheets are aligned. If the paper overlaps within the Save drum or the timing of pulling in the third and subsequent sheets is shifted, the edges of the sheets will not align. Cause There is a gap in the timing of overlapping of the second sheet and the third sheet in the backup drum. There is a gap in the pull-in timing of the sheets up to the 3rd and the 4th subsequent sheets. Corrective Actions Remedy 1: Adjust the position of the second sheet and the third sheet in the backup drum. Remedy 2: Adjust the paper pull-in timing for the 3rd and the 4th and subsequent sheets. Reference Page page 4-60 page 4-61 Remedy 1: Adjusting the position of the second sheet and the third sheet in the backup drum 1 [Home] key > [...] > [Professional Settings] > [246 Adjust Finisher] > [01 Finisher] > [09 Save Drum(2nd F)], [10 Save Drum(3rd C)], or [11 Save Drum(2nd C)] 2 Adjust the setting value using [+], [-] key and numeric keypad. The range of the set value is as follows. 4-60