Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 162

Troubleshooting > Troubleshooting When Discharging Paper Remedy 4: Adding a correction value to support thick paper 1 [Home] key > [...] > [Professional Settings] > [246 Adjust Finisher] > [01 Finisher] > [18 Punch(T) Resist] 2 Adjust the setting value using [+], [-] key and numeric keypad. The range of the set value is as follows. Item 18 Punch(T) Resist Range -20 to 20 Default 0 Amount of change 0.15 mm 3 Press the [Start] key > [Stop] key. The staple position is misaligned Cause The center position of the staples is misaligned. The position of the front/back staple is different from the specified amount. Corrective Actions Reference Page Remedy 1: Adjust the position of the staples evenly from the center. page 4-59 Remedy 2: Adjust the position of the front page 4-60 or back staple. Remedy 1: Adjusting the position of the staples evenly from the center 1 [Home] key > [...] > [Professional Settings] > [246 Adjust Finisher] > [01 Finisher] > [08 Staple HP] 2 Adjust the setting value using [+], [-] key and numeric keypad. The range of the set value is as follows. Item Range Default Amount of change 08 Staple HP -30 to 30 0 0.19 mm If the staple position is shifted to the front side of the machine (Sample 1), increase the set value. If the staple position is shifted to the rear side of the machine (Sample 2), lower the set value. 4-59