Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 160

Troubleshooting > Troubleshooting When Discharging Paper Punch position is misaligned Cause Corrective Actions The position of the punched hole is misaligned forward or backward with respect to the end face of the paper (there is a difference between front and back). Remedy 1: Adjust the back and forth difference of the punched hole. The stop timing of the position to Remedy 2: Adjust the stop timing of the open the punch hole is not position to open the punch hole. correct. The center position of the punched hole is misaligned. Remedy 3: Adjust the positions of the punched holes evenly from the center. Holes were punched in the thick Remedy 4: Add a correction value to paper. support thick paper. Reference Page page 4-57 page 4-58 page 4-58 page 4-59 Remedy 1: Adjusting the back and forth difference of the punched hole 1 [Home] key > [...] > [Professional Settings] > [246 Adjust Finisher] > [01 Finisher] > [01 Punch Resist] 2 Adjust the setting value using [+], [-] key and numeric keypad. The range of the set value is as follows. Item Range Default Amount of change 01 Punch Resist -20 to 20 0 0.15 mm If the paper is conveyed obliquely (Sample 1), increase the setting value. If the paper Z-folds (Sample 2), lower the setting value. Sample 1 Sample 2 3 Press the [Start] key > [Stop] key. 4-57