Kyocera TASKalfa Pro 15000c Pro 15000c Advanced Operation Guide - Page 130

Troubleshooting > Troubleshooting When Printing Image 3 Align the mark on the chart arrow with the mark on the upper left corner of the platen glass. As shown in the illustration, place the pattern on the glass platen with the printed side down and the edge with the arrows toward the back. NOTE The printed position of the arrows in the nozzle check pattern may be in from the edge, depending on the size of the pattern. Regardless of the position of the arrows, place the pattern in the upper left corner of the glass platen. 4 Select [Start]. After the pattern is scanned, the number of clogged nozzles of each color is displayed. If there is even one clogged nozzle, go to the next step. 5 [Stop] key > select [01 Cleaning]. 6 Select the color which has clogged nozzles > select [Strong] as the strength of cleaning > [Start] key. The head cleaning begins. 7 If the nozzle clog is not solved using head cleaning three times, change the strength of cleaning to [Ex Strong] and execute cleaning three times. 8 In case that no improvement is observed, contact our service representative. 2 Depending on the usage environment, set discharge mode and waste paper. 1 Select a setting number that is applicable to usage conditions. Print Speed Images per job Paper Size Action Full speed 600 dpi mode 200 images and more Larger than A4/Letter A4-R/ Letter-R or smaller than A4/Letter Setting 1 Setting 2 199 images and All size less Setting 3 4-27