Lexmark M410 Service Manual - Page 84
ROM Memory Test, Parallel Wrap Test, To run the ROM Memory Test
UPC - 734646261005
View all Lexmark M410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4045-XXX ROM Memory Test The ROM Memory Test is used to check the validity of the RIP code and fonts. To run the ROM Memory Test: 1. Select ROM Memory Test from the menu. P and F represent the same numbers for DRAM. - The power indicator blinks indicating the test is in process. The test runs continuously. 2. Press Return/Stop to exit the test. Each time the test finishes, the screen updates with the result. If the test passes, the Pass Count increases by 1, however if the test fails, one of the following messages displays for approximately three seconds: ROM Checksum Error ROM Burst Read Error Once the maximum pass count or fail count is reached, the test stops with the power indicator on solid. The final results display on the screen. Parallel Wrap Test This test is used with a wrap plug to check operation of the parallel port hardware. Each parallel signal is tested. To run the Parallel Wrap Test: 1. Disconnect the parallel interface cable and install the wrap plug (P/N 1319128). 2. Select the Parallel Wrap Test from the menu. - The power indicator blinks indicating the test is in progress. The test runs continuously until canceled. 3-10 Service Manual