Panasonic DMR-HW100EBK Operating Instructions - Page 81

Software (Firmware) Update Software of this unit can be updated automatically by the following methods when this unit is in the standby mode or when it is 3 a.m. (> 79, Software Update in Standby) -From broadcasts -From Internet§ ≥To update the Software (Firmware) immediately, use the following function: -Software Update Now ( Broadcast ) (> 79) Software of this unit will be updated from broadcasts if update information is detected. -Software Update Now ( Internet )§ (> 79) Software of this unit will be updated from Internet if update information is detected. § Network connection and setting are required. (> 12, 15) ∫ If a software (firmware) update is available, a notification is displayed. New software version has been found. The software will be updated automatically after this unit is switched to standby. Do not disconnect the AC mains lead. ∫ The unit's display during the update e.g., ≥When "FINISH" is displayed, update of the software (firmware) has completed. You cannot operate the unit until the update is complete. Removing the AC mains lead while the update is in progress may damage the unit. Don't remove the AC mains lead during the update. ≥ It may take up to a few hours until the update is completed depending on the network or broadcast environment. ≥ If the timer recording is scheduled within the following time at the start of the download, the download will not be executed. - From broadcast: Within 5 hours - From Internet: Within 1 hour ≥ You can also download the latest software (firmware) from the following website. http://panasonic.jp/support/global/cs/ ≥ If you do not want to perform the software (firmware) update, set the "Software Update in Standby" to "Off". (> 79) ≥Update of the software (firmware) will start when the unit is turned to standby mode. Convenient functions 81 VQT3F57